Hi , Friends !
i am using ASA Active and Active Failover Design
the Issue is that when both ASA Firewalls are powered off and i Power on Only one ASA at the time the ASA is waiting for more than 20 mins and shows all interfaces as
act/sec/SRV-A(config)# show fa
Failover On
Interface TO-O (x.x.x.x): No Link (Waiting)
Interface TO-P (x.x.x.x): No Link (Waiting)
Interface TO-D (x.x.x.x): No Link (Waiting)
When i change polling times for less that 10 seconds, it shows < WARNING: command has no effect for active/active failover >
As well when i want to manually Active ASA
stby/sec(config)# failover active
This unit is in syncing state. 'failover' command will not be effective at this time
i want to design the network in such a way that when ASA comes up it dose not wait for peer for long time and goes as Active ASAP
Here the question created in my mined that if i have power issue in Datacenter and face to ASA Damage problem, when i power 1 ASA on should it take such this long time that my network work normally ?
Please Help !
