How do I make the primary the secondary and vice versa. 192.168.1.10 should be the primary/active and 192.168.1.100 should be the secondary/standby. Thanks.
John
show failover
Failover On
Failover unit Primary
Failover LAN Interface: failover Ethernet0/2 (up)
Unit Poll frequency 1 seconds, holdtime 15 seconds
Interface Poll frequency 5 seconds, holdtime 25 seconds
Interface Policy 1
Monitored Interfaces 6 of 250 maximum
Version: Ours 8.2(1), Mate 8.2(1)
Group 1 last failover at: 20:59:12 EDT Jun 22 2013
Group 2 last failover at: 20:59:12 EDT Jun 22 2013
This host: Primary
Group 1 State: Standby Ready
Active time: 0 (sec)
Group 2 State: Standby Ready
Active time: 0 (sec)
slot 0: ASA5510 hw/sw rev (2.0/8.2(1)) status (Up Sys)
aux-470-fw Interface outside (192.168.1.100): Normal
aux-470-fw Interface inside (192.168.1.100): Normal
aux-865-fw Interface outside (0.0.0.0): Normal (Waiting)
aux-865-fw Interface inside (0.0.0.0): Normal (Waiting)
aux-864-fw Interface outside (0.0.0.0): Normal (Waiting)
aux-864-fw Interface inside (0.0.0.0): Normal (Waiting)
slot 1: empty
Other host: Secondary
Group 1 State: Active
Active time: 139935 (sec)
Group 2 State: Active
Active time: 139831 (sec)
slot 0: ASA5510 hw/sw rev (2.0/8.2(1)) status (Up Sys)
aux-470-fw Interface outside (192.168.1.10): Normal
aux-470-fw Interface inside (192.168.1.10): Normal
aux-865-fw Interface outside (192.168.1.250): Normal (Waiting)
aux-865-fw Interface inside (192.168.1.250: Normal (Waiting)
aux-864-fw Interface outside (1192.168.1.190): Normal (Waiting)
aux-864-fw Interface inside (192.168.1.190): Normal (Waiting)
slot 1: empty
