03-09-2020 06:48 AM
Hello everyone,
I would like to add couple of addresses to existing network list.
Once I click edit on the list, I can only delete existing addresses or save the config.
I don't see the add option. Please advise.
Regards,
Daniel
Solved! Go to Solution.
03-10-2020 03:54 AM - edited 03-10-2020 03:57 AM
Once you've created the Network List, you would need to modify your Access Policy, go to the Security Intelligence tab and then select the list (add to whitelist).
E.g. - custom list called "IP_List" added to Whitelist.
You will also be able to determine whether the Policy is using the Global Whitelist/Blacklists.
03-09-2020 06:55 AM
03-09-2020 07:30 AM
03-09-2020 08:52 AM
You can select the pencil icon to the right of the list, which will open the window below. You can then click download, upload the list in notepad, edit and then re-upload.
If you don't see that, please upload a screenshot.
HTH
03-09-2020 10:53 AM
03-09-2020 11:07 AM
You go to connection > events, right click the IP address and then select either Blacklist or Whitelist IP address. The IP address would then appear in the Blacklist or Whitelist you referenced.
03-10-2020 02:11 AM
What if the connection has not been ever established to those addresses.
The addresses are not shown in the events.
Regards,
Daniel
03-10-2020 02:40 AM
You could just generate some traffic to the address(s), monitor in the connection events and then add to the global whitelist/blacklist.
Or just create a custom list (as per the screenshot I previously providied), that would perhaps allow you the ability to add/remove easier.
03-10-2020 02:48 AM
03-10-2020 03:54 AM - edited 03-10-2020 03:57 AM
Once you've created the Network List, you would need to modify your Access Policy, go to the Security Intelligence tab and then select the list (add to whitelist).
E.g. - custom list called "IP_List" added to Whitelist.
You will also be able to determine whether the Policy is using the Global Whitelist/Blacklists.
03-09-2020 08:37 AM
Hello,
I think you need to do that on the Object - Object Management then find the object you need to modify and click on the pencil icon on the right hand then choose range then save the configuration and go back to policies - access control chose the object and deploy, this should sort the problem.
SS
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide