Hi all,
I am trying to add my cisco firepower 2130 appliances to my FMC.
According to the link (https://www.youtube.com/watch?v=eshXpBPPKPg), from the console CLI, after entering the default username and password, it should prompt me to accept EULA after which I can proceed to set my management interface ip and specify my FMC ip address using "configure manager add x.x.x.x".
But after I enter the default username and password there is no EULA. And there is only a limited amount of commands as below. Why is this so? How do I proceed, please advise.
1)acknowledge
2)backup
3)clear
4)commit-buffer
5)connect
6)discard-buffer
7)end
8)exit
9)gcov
10)scope
11)set
12)show
13)terminal
14)top
15)up
16)where
