1462
Views
0
Helpful
1
Replies
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-19-2019 02:59 PM
Hello all,
I am trying to setup Anyconnect on my ASA which its outside IP configuration is DHCP, means I have dynamic IP address on my outside interface. Is it possible to configure Anyconnect with dynamic IP address or we have to order public static IPs?
Thanks,
Ramin
Solved! Go to Solution.
Labels:
- Labels:
-
Firewalls
1 Accepted Solution
Accepted Solutions
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-19-2019 10:55 PM
If you use dynamic IP, then you need to register ASA with dynamic DNS
server to keep updating its IP whenever it changes.
See examples here.
https://www.cisco.com/c/en/us/td/docs/security/asa/asa84/configuration/guide/asa_84_cli_config/basic_ddns.html
server to keep updating its IP whenever it changes.
See examples here.
https://www.cisco.com/c/en/us/td/docs/security/asa/asa84/configuration/guide/asa_84_cli_config/basic_ddns.html
1 Reply 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-19-2019 10:55 PM
If you use dynamic IP, then you need to register ASA with dynamic DNS
server to keep updating its IP whenever it changes.
See examples here.
https://www.cisco.com/c/en/us/td/docs/security/asa/asa84/configuration/guide/asa_84_cli_config/basic_ddns.html
server to keep updating its IP whenever it changes.
See examples here.
https://www.cisco.com/c/en/us/td/docs/security/asa/asa84/configuration/guide/asa_84_cli_config/basic_ddns.html
