Anyone try to use the ASDM 6.2(3) or ASDM 6.2(5) demo mode downloads?

[dmckillip]

I have had problems trying to run ASDM-demo versions 6.2(3) and 6.2(5)

in demo mode....The attached screenshot shows what I get....it is as if the

demo software is missing; the image size for these downloads exceeds the

size of the ASDM demo 6.2(1) which works just fine.  Is there something I am

missing in installing the newer versions?

[praprama]

Hi,

Have you installed the file asdm-demo-625.msifrom the below link:

http://tools.cisco.com/support/downloads/go/ImageList.x?relVer=6.2.5&mdfid=279513399&sftType=Adaptive+Security+Appliance+%28ASA%29+Device+Manager&optPlat=&nodecount=3&edesignator=null&modelName=Cisco+Adaptive+Security+Device+Manager&treeMdfId=2684381...

If not, please install that and then run it in demo mode to see if it works fine. Let me know how it goes!!

Thanks and Regards,

Prapanch

[dmckillip]

Prapanch,

...No, this is the same distribution that gave me the error.

After I posted this note, I found the Bugtraq message

attached; however, I could not find a demo mode release

6.2(5.50) referenced in this posting.  If you could point me

in the right direction to download that, it would be appreciated.

Thanks,

Doug

[praprama]

Hi,

Seems to indeed be that bug. To get that version, you will need to open up a TAC case and get this file published for you. It is not available for download on CCO.

Hope this helps!!

Thanks and Regard,

Prapanch

[dmckillip]

Could you please point me to a URL

to submit a TAC case for this?  Seems

like the web page I get to wants a serial

number for a hardware device....All I

want is a general TAC submission page.

Thanks,

Doug

[praprama]

Hi,

You need a serial number under a Valid contract for opening up a TAC case. its not possible to do it without that.