ASA 5510 context base configuration in HA Mode with two different subnet

[sanjeevmahadani]

Hi

Please someone help me to configure the Firewall ASA 5510 in context based configuration in HA Mode with two different subnet....

IP Details are below.....:

interface Ethernet0/0

nameif outside

security-level 0

ip address 10.10.10.2 255.255.255.0 standby 10.10.10.3

!

interface Ethernet0/1

no nameif

security-level 0

no ip address

!

interface Ethernet0/1.101

description INSIDE1

vlan 101

nameif INSIDE1

security-level 90

ip address 172.22.0.2 255.255.255.0 standby 172.22.0.3

interface Ethernet0/1.102

description INSIDE2

vlan 102

nameif INSIDE2

security-level 80

ip address 172.22.1.2 255.255.255.0 standby 172.22.1.3

interface Ethernet0/3

description LAN Failover Interface

failover

failover lan unit primary

failover lan interface FAILOVER Ethernet0/3

failover replication http

failover interface ip FAILOVER 192.168.3.1 255.255.255.0 standby 192.168.3.2

route outside 0.0.0.0 0.0.0.0 10.10.10.1 1

[varrao]

Hi Sanjeev,

If it is a context based configuration  that you are doing then, you would need to configure context on the ASA first, you can refer to this document for it:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00808d2b63.shtml

Thanks,
Varun Rao
Security Team,
Cisco TAC