ANNOUNCEMENT - The community will be down for maintenace this Thursday August 13 from 12:00 AM PT to 02:00 AM PT. As a precaution save your work.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

873
Views
0
Helpful
5
Replies
Highlighted
Beginner

ASA 5550 Module 1 Interface

Please let me know is it possible to use ports from 2 SFP and 2 RJ45 Interface on ASA 5550 Module 1.

Regards

Imr

5 REPLIES 5
Highlighted
Advocate

ASA 5550 Module 1 Interface

Hi,

Yes you can use them, if yeou are referencing to the ones shown in the doc blow:

http://www.cisco.com/en/US/docs/security/asa/hw/maintenance/guide/overview.html

Hope that helps

Thanks,

Varun

Thanks, Varun Rao Security Team, Cisco TAC
Highlighted
Beginner

Re: ASA 5550 Module 1 Interface

Thanks varun,

yes I was referring to Figure 1-3     Rear Panel LEDs and Ports for the Cisco ASA 5550

Basically I need to use

GigabitEthernet ports -  GigabitEthernet 1/0, GigabitEthernet 1/1,

SFP ports -  GigabitEthernet 1/2, and GigabitEthernet 1/3

Both at the same time

I hope this works fine as you said.

Regards

imr

Highlighted
Advocate

ASA 5550 Module 1 Interface

Yes that should work fine as per your requirement.

Thanks,

Varun

Thanks, Varun Rao Security Team, Cisco TAC
Highlighted
Beginner

Re: ASA 5550 Module 1 Interface

Thanks for the confirmation.

Just to add to this question, does the SFP ports supports both singlemode and mutimode SFPs.

Regards

Imran

Highlighted
Beginner

ASA 5550 Module 1 Interface

Not sure if you made a typo, but you can only use one media-type or the other in the SSM module. So you should be using slot0 for your copper and slot1 for fiber. And yes the SSM supports both SM and MM, but you would typically only use SM for very long distances.