ASA connection

[sanju250.shukla]

Dear Friends,

I have ASA 5505,i have already connected through leased line and site is runing.Now client requirement is to connect one more broadband line into firewall.So please assist me whether i can connect 2 line(Leased and broadband) simultaneously or have to make 2 static route for one by one operation in case of failure.

Thanks.

[Jennifer Halim]

You can't configure 2 default gateway off 2 different interfaces on the ASA as it is not supported.

You would need to configure ISP failover with SLA feature so if your leased line fail, it will failover to your broadband connection.

Here is the configuration guide for your reference:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00806e880b.shtml

Hope this helps.

[sanju250.shukla]

Thanks a lot for your support.

I would like to one more thingt that if i dont use sla monitor then can i

use all like same as mentioned in document?

Please assist.

Thanks & Regards'

Sanjeev Shukla

+91 9662335700

On Mon, Sep 5, 2011 at 11:33 AM, halijenn <

[Jennifer Halim]

You would need to use SLA monitor, otherwise, the failover will not be automatic unless the primary interface of the first ISP is completely down.