ASA-CX Module Authentication Solution
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-28-2014 10:06 PM - edited 03-11-2019 09:49 PM
we have CX-Module with the latest version , we are facing some bandwidth issues with some users , we want to limit these users and block some websites for them
but the issue that , these Users is a DHCP , and we cannot apply a policy for all subnet
I thought to control it by MAC address , but CX-Module doesn`t support that
So ; is there any authentication Solution on CX-Module so can control these users by the user name
But Locally on Cx-Module NOT Users joining the Domain
- Labels:
-
NGFW Firewalls

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-04-2014 08:16 PM
You can try to apply the policies for the DHCP scope of IP addresses that you are using.
The CX would not be able to use the LOCAL usernames without having a AD server.
Thanks and Regards,
Vibhor Amrodia
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-24-2014 12:39 PM
Dude you need to setup the Cisco Context Directory Agent. This will allow it to integrate to your active directory. Then is just a matter of putting the users into a AD group (ex. Restricted Bandwidth Group) and making a policy in PRSM for the group. On the policy there is an option to throttle traffic. I do this to the really bad users.
