ASA drops port forwarding

[n.kiskeidze]

I'm trying to forward port 4520 on my local IP Camera.

I have only two interfaces inside and outside with security levels 100 and 0.

I have already done nat overload.

In Access rules I have such situation : 

and in NAT :

but when I'm trying to connect from Source network or packet tracer it's dropping.

[Farhan Mohamed]

You should have static port forward rule on top of dynamic PAT rule. The dual NAT table goes from top to bottom.

Also I would suggest to put "show run nat"  and "show run object" in the output here.