ASA failover is not replicating configuration

[Luis Carranza]

Hi:

I discover an issue with my CISCO ASA 5550 because I'm looking at the vlans that I have configured and some vlans on the Stand by device had not an IP address configured, checking the configuration of the failover I don't see anything wrong so I don't if maybe I'm missing something, Can you help me please, and if you need more information about my configuration let me know.

Regards.

[Marvin Rhoads · Accepted solution]

There will only be a standby IP address assigned if the active configuration specifies one in the interface configuration section. It's optional whether or not to use standby IP addresses.

[Luis Carranza]

Thanks for the answer Marvin!! It was really helpful.

Regards