cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

477
Views
0
Helpful
2
Replies
Highlighted
Beginner

ASA failover is not replicating configuration

Hi:

I discover an issue with my CISCO ASA 5550 because I'm looking at the vlans that I have configured and some vlans on the Stand by device had not an IP address configured, checking the configuration of the failover I don't see anything wrong so I don't if maybe I'm missing something, Can you help me please, and if you need more information about my configuration let me know.

Regards.

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Hall of Fame Guru

There will only be a standby IP address assigned if the active configuration specifies one in the interface configuration section. It's optional whether or not to use standby IP addresses.

View solution in original post

2 REPLIES 2
Highlighted
Hall of Fame Guru

There will only be a standby IP address assigned if the active configuration specifies one in the interface configuration section. It's optional whether or not to use standby IP addresses.

View solution in original post

Highlighted

Thanks for the answer Marvin!! It was really helpful.

Regards

Content for Community-Ad