cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
647
Views
5
Helpful
3
Replies

asa failover pair

Kris Wolton
Level 1
Level 1

Hi,

This may be a stupid question, but if I have an active/passive pair how do I connect to the passive box? I need to upload a any connect image.

Sent from Cisco Technical Support iPad App

3 Replies 3

varrao
Level 10
Level 10

Hi Kris,

Kindly go through this doc, this would clear all your questions regarding the failover and connectivity bnetween two boxes:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00807dac5f.shtml

Hope this helps.

Thanks,

Varun

Thanks,
Varun Rao

John Blakley
VIP Alumni
VIP Alumni

You can telnet/ssh into the physical address of the passive unit. (Note: This is the address that you assigned the standby when it's not in the primary state. It's the physical address of the inside interface.)

HTH,

John

HTH, John *** Please rate all useful posts ***

hi, turns out I had not configured an ip address to the second box, called Cisco tac and they assisted me configuring one, all good now.

Sent from Cisco Technical Support iPad App

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: