asa failover pair

[Kris Wolton]

Hi,

This may be a stupid question, but if I have an active/passive pair how do I connect to the passive box? I need to upload a any connect image.

Sent from Cisco Technical Support iPad App

[varrao]

Hi Kris,

Kindly go through this doc, this would clear all your questions regarding the failover and connectivity bnetween two boxes:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00807dac5f.shtml

Hope this helps.

Thanks,

Varun

[John Blakley]

You can telnet/ssh into the physical address of the passive unit. (Note: This is the address that you assigned the standby when it's not in the primary state. It's the physical address of the inside interface.)

HTH,

John

[Kris Wolton]

hi, turns out I had not configured an ip address to the second box, called Cisco tac and they assisted me configuring one, all good now.

Sent from Cisco Technical Support iPad App