Hi,
We experience an automatic failover from our Cisco ASA, our standby just went active without any changes on the config and problems on our network. We are not able to get some logs during the failover. From the output below, I would like to seek for any help if there is something wrong on the ASA ASA5585-SSP-10 8.2(5) during the automatic failover we encountered.
below is part of show tech output.
------------------ show failover history ------------------
==========================================================================
From State To State Reason
==========================================================================
00:44:30 PDT Oct 3 2013
Not Detected Negotiation No Error
00:44:37 PDT Oct 3 2013
Negotiation Cold Standby Detected an Active mate
00:44:39 PDT Oct 3 2013
Cold Standby Sync Config Detected an Active mate
00:44:48 PDT Oct 3 2013
Sync Config Sync File System Detected an Active mate
00:44:48 PDT Oct 3 2013
Sync File System Bulk Sync Detected an Active mate
00:45:01 PDT Oct 3 2013
Bulk Sync Standby Ready Detected an Active mate
00:58:26 PDT Oct 3 2013
Standby Ready Just Active Set by the config command
00:58:26 PDT Oct 3 2013
Just Active Active Drain Set by the config command
00:58:26 PDT Oct 3 2013
Active Drain Active Applying Config Set by the config command
00:58:26 PDT Oct 3 2013
Active Applying Config Active Config Applied Set by the config command
00:58:26 PDT Oct 3 2013
Active Config Applied Active Set by the config command
==========================================================================
Thanks.
