Our primary unit failed over yesterday stating communication failure, but I want to failback. I used the failover active command, but I'm assuming that is not going to work since failover seems to be 'off'.
FW-IN01# sh failover
Failover Off
Failover unit Secondary
Failover LAN Interface: Sync Ethernet0/3 (up)
Unit Poll frequency 1 seconds, holdtime 15 seconds
Interface Poll frequency 5 seconds, holdtime 25 seconds
Interface Policy 1
Monitored Interfaces 3 of 250 maximum
FW-IN01# sh running-config failover
no failover
failover lan unit secondary
failover lan interface Sync Ethernet0/3
failover key *****
failover link Sync Ethernet0/3
failover interface ip Sync 172.16.111.1 255.255.255.0 standby 172.16.111.2
