11-09-2015 11:16 PM - edited 03-11-2019 11:51 PM
Hi all,
i have cisco ASA which cover CME inside the network, i config IPsec site-to-site VPN, NAT static, also some ACL.
i've allow SIP TCP and UDP but it seem still cannot allow RTP/UDP from outside to inside, the clue was ip phone can call and ringing but
there is no voice, i've check in ASA and found from packet tracer that the UDP packet stop at outside interface in my ASA.
please advice, and if any guide to solve this
Regards,
acer
11-10-2015 12:52 AM
Hi,
Could you please check if 'SIP' inspection is enabled on ASA. As you are using NATs, you need to use SIP inspection on ASA.
Regards,
Aksahy Rastogi
11-10-2015 01:07 AM
Hi akshay,
thank you for answer, can you please share any guide regarding sip inspection ?
thanks
11-10-2015 01:12 AM
Hi,
Please find the link below:
http://www.cisco.com/c/en/us/td/docs/security/asa/asa82/configuration/guide/config/inspect_voicevideo.html
Hope it helps.
Regards,
Akshay Rastogi
Remember to rate the helpful posts and mark the answer as correct if it answers your query.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide