ASA Http-map

[delawarecity]

I was trying to add peer 2 peer blocking on our ASA 5100 (7.2.2) using the HTTP-Map command. The ASA responded saying that command has been depreciated. It said I should use a policy map command instead. I looked at the 7.2 command reference but, I didn't see anything new under the policy map section. What the new command? Thanks for your help.

[thomas.chen]

In order to enable HTTP application inspection or in order to change the ports to which the security appliance listens, use the inspect http command in class configuration mode.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a008085283d.shtml