Hi,
I have 2 ASA 550, one is active with its failover with version 7.2(2).
I want to upgrade this image to 8.0(3), if this possible, and if so, i must do it for every one alone or on one of them and it will be copied by default to the failover.
Here you are my ASA version:
Cisco Adaptive Security Appliance Software Version 7.2(2)
Device Manager Version 5.2(2)
Compiled on Wed 22-Nov-06 14:16 by builders
System image file is "disk0:/asa722-k8.bin"
Config file at boot was "startup-config"
Primary-ASA-Plant up 13 days 15 hours
failover cluster up 13 days 15 hours
Hardware: ASA5510-K8, 256 MB RAM, CPU Pentium 4 Celeron 1600 MHz
Internal ATA Compact Flash, 256MB
BIOS Flash M50FW080 @ 0xffe00000, 1024KB
Encryption hardware device : Cisco ASA-55x0 on-board accelerator (revision 0x0)
Boot microcode : CNlite-MC-Boot-Cisco-1.2
SSL/IKE microcode: CNlite-MC-IPSEC-Admin-3.03
IPSec microcode : CNlite-MC-IPSECm-MAIN-2.04
0: Ext: Ethernet0/0 : address is 001b.53fe.eb0a, irq 9
1: Ext: Ethernet0/1 : address is 001b.53fe.eb0b, irq 9
2: Ext: Ethernet0/2 : address is 001b.53fe.eb0c, irq 9
3: Ext: Ethernet0/3 : address is 001b.53fe.eb0d, irq 9
4: Ext: Management0/0 : address is 001b.53fe.eb09, irq 11
5: Int: Internal-Data0/0 : address is 0000.0001.0002, irq 11
6: Int: Internal-Control0/0 : address is 0000.0001.0001, irq 5
Licensed features for this platform:
Maximum Physical Interfaces : Unlimited
Maximum VLANs : 100
Inside Hosts : Unlimited
Failover : Active/Active
VPN-DES : Enabled
VPN-3DES-AES : Enabled
Security Contexts : 2
GTP/GPRS : Disabled
VPN Peers : 250
WebVPN Peers : 2
This platform has an ASA 5510 Security Plus license.
Serial Number: JMX1120L0R4
Running Activation Key: 0xca0b6378 0x089236f1 0x6ce17d60 0xbeec9854 0x42001e80
Configuration register is 0x1
Configuration last modified by enable_1 at 06:34:23.198 UTC Tue May 4 2010
