ASA - Logging ACL hits

[nikolaj.joeker]

Hi there,

I would like to configure syslog, so I get only Allow and Deny from the ACL.

I tried to configure an Event List with some Message ID's.  But the logging seemed not to be the selected ID's, but * a lot * more.

Any pointers?

regards Nikolaj

[nspasov]

Hi there! Please have a look at the link below. It is an older document but still useful:

https://www.cisco.com/c/en/us/td/docs/security/asa/asa84/configuration/guide/asa_84_cli_config/acl_logging.pdf

I hope this helps!

Thank you for rating helpful posts!