cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
13372
Views
0
Helpful
5
Replies

ASA message 609001

danielnunes
Level 1
Level 1

Folks,

I am getting many erros on ASDM like this. (609001, 609002)

Everything sound works perfect but I saw that messages are related with error messages, however there is no actions to do about that message.

does anyone knows about that message? or anything wrong about it.

7Dec 12 201019:20:27609001200.201.202.203Built local-host Internet:200.201.202.203

7Dec 12 201019:20:27609002200.201.202.203Teardown local-host Internet:200.201.202.203 duration 0:00:00

thanks a lot

1 Accepted Solution

Accepted Solutions

It's not really an error. It falls under debugging messages, and it provides you with additional information if you are troubleshooting for anything in particular.

If you do not want to get those debugging messages as if you configure debugging level (level 7) syslog, it will give you or log a lot of information which is only important during troubleshooting/investigation.

I would recommend that you lower down the syslog level to informational or notification, so it doesn't log all those debugging messages.

Here is what each syslog level logged for your reference:

http://www.cisco.com/en/US/docs/security/asa/asa82/system/message/logsevp.html

View solution in original post

5 Replies 5

Jennifer Halim
Cisco Employee
Cisco Employee

Yes, nothing to worry at all. It just advised you when a new connection is being built and when it is being torn down.

Here is the syslog message explaination for your reference:

609001:

http://www.cisco.com/en/US/docs/security/asa/asa82/system/message/logmsgs.html#wp4774514

and 609002 is just the next one down the page.

Hope that helps.

Why does Cisco put this message as a "Error Message "? if this message is not related with errors?

thanks

It's syslog messages

Could you explain a little bit more about?

because on ASA Guide that messages are related with errors..

"609001 Error Message %PIX|ASA-7-609001: Built local-host interface_name:IP_address"

I know that message is a debug level but there is no error, is a normal behaviour.

thanks

It's not really an error. It falls under debugging messages, and it provides you with additional information if you are troubleshooting for anything in particular.

If you do not want to get those debugging messages as if you configure debugging level (level 7) syslog, it will give you or log a lot of information which is only important during troubleshooting/investigation.

I would recommend that you lower down the syslog level to informational or notification, so it doesn't log all those debugging messages.

Here is what each syslog level logged for your reference:

http://www.cisco.com/en/US/docs/security/asa/asa82/system/message/logsevp.html

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card