ASA Multiple Context NAT problem

[fwpsamcisco]

Dear all,

I am having problem when configuring NAT in multiple context. Since the 2 context are sharing the same subnet in some interfaces, I use the same nat/global command in both contexts. But turns out reporting 'the same global ip is used by another context'. Is there any clue on this?

Thanks in advance.

Br,

Sam

[sebastan_bach]

hi sam u would get this error when u are using a shared interface in multiple context mode. make sure to use different global addresses when using a shared interface. when using seperate interfaces in context u will not face this problem.

see ya

regards

sebastan