ASA Packet Capture

[jonk34567]

In packet capture options when i mention the source or source and destination , packet capture buffer only displays the ingress interface traffic and it does not show any Egress interface traffic. Below i have attached the screenshot. what could be the reason for this ? 

[georgehewittuk1]

Does the route to the destination actually go out of interface wan1. (Check routing table)

Seems maybe like a misconfiguration of the wizard can you share the configuration of the egress capture?

[jonk34567]

yes it goes via Wan1.

[georgehewittuk1]

Hello,

In that case as you are seeing traffic return successfully likely to be a capture issue/configuration issue. I would try from the CLI and capture on the egress i.e. the wan2 so...

cap cap1 interface wan2 match ip host x host y

You can do a show capture cap1 detail should see results.

GH