12-30-2019 06:41 AM
In packet capture options when i mention the source or source and destination , packet capture buffer only displays the ingress interface traffic and it does not show any Egress interface traffic. Below i have attached the screenshot. what could be the reason for this ?
12-30-2019 07:28 AM - edited 12-30-2019 07:28 AM
Does the route to the destination actually go out of interface wan1. (Check routing table)
Seems maybe like a misconfiguration of the wizard can you share the configuration of the egress capture?
12-30-2019 08:56 AM
12-31-2019 01:07 AM
Hello,
In that case as you are seeing traffic return successfully likely to be a capture issue/configuration issue. I would try from the CLI and capture on the egress i.e. the wan2 so...
cap cap1 interface wan2 match ip host x host y
You can do a show capture cap1 detail should see results.
GH
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide