ASA transparent mode

[sahrizal123]

Hi,

Currently i have network install by Juniper firewall and plan to change to Cisco 5516-x ( 9.6 ).

Current setup at Juniper-->

Server NIC configure by public IP
Public IP have different 4 subnet ( 203.x.x.32/28 , 210.b.c.160/29 ,  210.b.c.80/29, 210.b.c.192/29 )
Each subnet have dedicated gateway provide by ISP. Server has different subnet depend on IP range above.
We access firewall from outside by 203.x.x.46

Default route 0.0.0.0 0.0.0.0  203.x.x.33
Firewall only has 2 cable to uplink( outside)  and INSIDE ( LAN )

As for new ASA firewall we plan to remain the same setup as above.

1. Should we configure the ASA to transparent mode ?

2.  The link below only show setup transparent mode for 1 subnet, how about we have 4 subnet ?

Is it require 4 vlan inside ?

http://ciscoasafirewall.blogspot.my/2011/06/cisco-asa-firewall-in-transparent.html

3. The version 9.6 require BVI ?

Thanks

[Ajay Saini]

Please keep in mind that transparent mode(BVI) does not support VPN and also the subnets can not point their gateway to ASA BVI ip address. ASA will sit transparently.

-AJ

[sahrizal123]

now i change to route mode since 3 others subnet cant reach from outside..

are u able to remote to my pc by teamviewer ?