07-15-2012 05:03 AM - edited 03-11-2019 04:31 PM
Dears,
i have one ASA running version (8.2) and another one running version (8.4).. i want to replace them with each other.. my question is: if i backup the configuration from (8.2) and upload it to (8.4), will this ASA (8.4) accept this configuration or should i migrate this configuration to the new version first? note that i want to keep the ASA (8.2) as it is to maintain a rollback plan.
Appreciate your Support Guys.
07-15-2012 06:38 AM
Hi Ahmad ,
in case you put the 8.2 config on the ASA running 8.4 directly , that will not work as it will refuse most of the commands ( NAT + Anyconnect ) due to the changes that have been added to 8.4.
if you load IOS 8.2 on the ASA and then the 8.2 config and upgrade the ASA to 8.4 then it will auto migrate the config directly .
if you want to have 8.2 then you can do that , just keep the image on the flash and also a backup config file for the 8.2 config and then use the downgrade command :
http://www.cisco.com/en/US/docs/security/asa/asa84/command/reference/d2.html#wp2002627
hope that this helps .
Mohammad.
07-15-2012 09:56 AM
Thx Mohammed,
Appreciate it.. that was really informative.
07-15-2012 11:05 AM
Hi Ahmad ,
you are more than welcome .
please remember to rate helpful posts .
thanks .
Mohammad.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide