10-13-2006 11:38 AM - edited 02-21-2020 01:14 AM
Hi,
We have a pix 506e which is working fine for client side vpn access to our network (192.168.10.x).
We now have a new site (192.168.20.x) and bought an ASA5510 to get a secure tunnel between the two sites. Although we have a tunnel established, we cannot ping from either end to the other network.
Unfortunately none of us are Cisco experts so have been using the guidance of a supplier who's specialist left the company today and us in the *^&%.
Can anyone point me in the right direction as to what we should be looking at - i'm suspecting it's just a routing issue but so far we have not been able to sort it.
I need to get this working ASAP, even if it means working over the weekend which i'm loathe to do unless someone can guide me through :)
Any help appreciated! If you need anymore information, just let me know what you need and i'll post it.
Si
10-14-2006 03:32 AM
post configs
10-14-2006 08:08 AM
Hi,
Specifically which parts - obviously if I post the entire file, it will compromise the security of the system :)
Si
10-14-2006 11:06 AM
Firstly, if you cannot post the configuration from both devices (taking out any sensitive information) then look at the following document:
The above document is for a spoke-to-spoke VPN configuration between three PIX devices but you should be only interested in the configuration between PIX1 and PIX2 in the document. I suspect the problem is related with the crypto ACL on the PIX?
Let me know if this helps or you need further help - good luck.
Jay
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide