ASAv30 CLI prompt hangs up when using show run commands.

[S.U.H.E.L]

Hardware: ASAv30
Cisco Adaptive Security Appliance Software Version 9.9(2)1

Whenever I try to enter any show run command, for example "show run" or "show run access-list", the CLI terminal hangs up without generating any output and I have to close the session and restart it. 

Even for "copy running-config startup-config", the same issue is observed.

Could this be related to high CPU usage? Kindly share your inputs and any suggestions to troubleshoot and narrow down this issue

[jimholla]

I've never seen this issue. Which hypervisor are you using? Also, 9.9.2 is a pretty old. Any chance you could use the 9.13 release? It has much better performance.

[S.U.H.E.L]

Hi @jimholla ,

This ASAv30 is deployed on the AWS using a "c4.xlarge" instance. I'd love to upgrade but since the show run commands are not working, I'm unable to take a backup of the device configuration.

[trhoads]

Does 'more system:running' do the same?  How about 'copy running tftp' or 'copy runn ftp'?  'Show tech'?

Thanks,

Tom