12-17-2009 08:50 AM - edited 02-21-2020 03:50 AM
ASDM 6.2(1) launched by Cisco Security Manager 3.3(1) against ASA 5520 running 8.0(5). I can run the wizard and everything looks normal but the capture statements are not applied to the ASA. We recently upgraded from ASDM 6.1(3), Cisco Security Manager 3.2(3) and ASA 8.0(4). With the old software, the packet capture wizard applied the capture commands to the ASA and removed them when the wizard finished. I could see the capture commands while the wizard was running when I typed SHOW RUN from the CLI of the ASA. With the new software, everything looks ok (no error messages) but the capture always shows no data and SHOW RUN doesnt show the capture commands.
12-17-2009 09:09 AM
CORRECTION: SHOW CAPTURE does not show the capture commands.
12-17-2009 09:35 AM
I ran the wizard via ASDM and I manually cut & pasted the capture statements on to the ASA via the CLI after hitting Start in the wizard. The wizard works from that point. The Get Capture Buffer and the Save Capture files buttons work. When I click Finish, the capture statements are actually removed. The problem seems to only effect ASDM's ability to send the capture commands. ASDM can still remove the capture commands.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide