Network Security

We just purchased a PIX 515 - no floppy disk. I know the procedure to perform the password recovery i.e. using tftp method but have no idea what the internal ip address is in order to execute the monitor > . Any other options/solution?Thanks.. Jacky

Hi!How can make FXP work through a PIX 501 6.2?FTP works fine. I`ve open port 2849 tcp and udp but it still wont work.I´ve been told to open a range of ports. How do I do that?access-list 102 permit tcp any any eq ftpaccess-list 102 permit tcp any an...

HelpI am following the documentation but having difficulty getting the pix to authenticate with the Microsoftg ca server.My debug message is:CRYPTO_PKI: WARNING: A certificate chain could not be constructed while selecting certificate statusWhat does...

I'm trying to use CSPM 3.0 for managing a PIX 515 with three interfaces and 4 VPNs terminated on it. I have already configured the PIX with CLI and works fine, but I just acquired CSPM3.0 and want to use it for management. The problem is that after I...

the outside ip address of my PIX is dynamicly assigned from my provider DHCP server.is there a way to define and inbound acl to allow inbound traffic to go thru with port redirection.my problem is that if my outside dynamic address change from 64.1.1...

Will this work, you need 32mb for for 6.2 image. Whats the deal..? Can upi up the mem. for the 501.. Anyone know ?thanks!

I am trying to connect a PIX 501 to our ISP (Cable service). I am unable to get a DHCP address fro the ISP, but DHCP works fine on a WIndows network (I plug the PIX into a port on the private network and I get an address from the Win2K DHCP server wi...

I have 2 PIX 520's setup with failover between the 2. If you unplug an interface that is in a switch or hub this will cause failover between the two... Failovers kill connections. I need to move the connections into a new switch without causing a fai...

Does the PIX support BW Management ??? If Yes how you configure it via CLI ???

Webtrends is lame and what we are currently using. What do you recommend and why?Thanks.

Can we integrate the IDS feature on PIX with the IDS appliance in order to have all alams reported on the CSPM Interface.

The new 515E has a VAC intergrated? does really support 5000 simultaneus tunnel vpn? How many tunnels was supported on the old 515?Thank's a lot.Graziano

I would like to mention that above mentioned combination is EXCELENT!!! Try it out... Remote access VPN is now just few clicks away... Sasa

I need to separate a OSPF area 0 with a firewall, becouse now some WAN connection are provided by a carrier in MPLS. I would like connect this WAN router outside the firewall, however I need also to extend the routing protocol OSPF to WAN. How I can ...

Will priority or custom queuing work along with an ipsec tunnel? Does the encryption occur prior to the queuing process?