Can I make single context failover preemptive

[g.eleftheriou]

Hello,

I have two firewalls in layer 3 mode, single context, active - standby.

Is it possible to make the primary after a failure to become active again, without having to type failover active?

thanks,

george

[francisco_1]

No.

Preempt only work in Active/Active failover mode.

Active/Active work in multiple context mode.

[Kureli Sankar]

That is correct. Preempt is only available in multiple context act/act mode. Pls. refer to the table in the below command reference link below:

http://www.cisco.com/en/US/docs/security/asa/asa82/command/reference/p.html#wp1868647

-KS