I have been trying to access FTD version 6.2 through Local Manager (FDM) by using default IP 192.168.45.45. but unfortunately, I could not able to access.
I have deployed FTD version 6.2 on the ASA5515-x box and also cabled the following deployment using switch which is recommended for ASA5515-x box as per mentioned in fptd-fdm-config-guide.
• Attach GigabitEthernet 0/0 to the ISP/WAN modem or other outside device. By default, the IP address
is obtained using DHCP, but you can set a static address during initial configuration.
• Attach GigabitEthernet 0/1 to the layer 2 switch. The IP address is 192.168.45.1, which serves as the
gateway for the inside network.
• Attach Management 0/0 to the layer 2 switch. The IP address is 192.168.45.45.
• Attach your workstation to the layer 2 switch and configure it to obtain an address using DHCP.
As per the above deployment, My workstation obtained the 192.168.45.46 ip address through dhcp from GigabitEthernet 0/1 inside network and also able to ping 192.168.45.1 but can not able to ping as well as access 192.168.45.45 management IP address. well also tried to access local manager though CLI but could not succeed in that case.
So my question is whether there is any problem on the module itself or in the management connection ?
