12-11-2012 11:43 PM - edited 03-11-2019 05:36 PM
Hi all,
I have a similar situation to here:
https://supportforums.cisco.com/thread/2048305
But i am using a Cisco 1841 with subinterfaces instead (NAT on a stick).
From the internet i can access services on public IP being hosted in LAN2. But when i try to access the same services on the same public IPs but sitting on LAN1, it does not work.
Any ideas?
Thanks.
12-11-2012 11:49 PM
Hi,
Usually when you have done Static NAT from a LAN2 to OUTSIDE it will apply to the traffic between those interfaces.
Traffic from LAN2 to LAN1 might require addiotional NAT configurations or might just not work.
I'm not too familiar anymore with the router side NAT configurations but to my understanding they dont really give as much flexilibility as the ASAs (old and new softawares)
- Jouni
12-11-2012 11:54 PM
Yes, i think my router is the one limiting here as it was working fine when i had this on a Checkpoint firewall. I just need confirmation from someone on here that it really cannot be done on an 1841 using NAT on a stick
12-11-2012 11:58 PM
Hi,
Would it be possible to do the same static NAT from LAN2 to LAN1 and test the setup?
Unless I missunderstood the situation.
- Jouni
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide