Can't configure IPS Banner via VMS 2.3

[rhermes]

The 5.x sensor's allows you to set a login banner with the "banner login" command on the CLI. This fills some legal obligations, but I have not found a way to set this via VMS so that I can push this out to all my sensors in one update. Please tell me VMS can do this. I do not want to configure each sensor by hand, and then have to re-import them all.

[b.speltz]

Try this link

http://www.cisco.com/en/US/products/hw/vpndevc/ps4077/products_configuration_guide_chapter09186a008055df94.html

[rhermes]

That page is part of a usefull set of pages describing how to configure the IPS Sensors using the CLI. In fact, a page from the same family discribes the CLI banner command: http://www.cisco.com/en/US/products/hw/vpndevc/ps4077/products_configuration_guide_chapter09186a008055df70.html#wp1030697

What I was asking is how to push this configuration from VMS 2.3, so I can set this option at a group level and push it out to 200 sensors in one shot.