Can you have a Active Active Cisco ASA over a WAN

[asmith1972]

Hi

We are running a large WAN MPLS network, with two datacentres. At each datacentre we have a internet link and a Cisco ASA firewall.

The Cisco ASA is running in a Active / Passive, so all our internet traffic is pushed through only 1 of our internet link.

Ideally we would like to loadbalance our internet traffic out of both links, so that our both our ASA firewalls are running Active / Active. Obvioulsy if one of the link fails we then want all the traffic to go out of just 1 of these links.

Does anyone know if its possible to setup this kind of configuration using a ASA over a WAN?

Thanks

[Maykol Rojas]

It can be done per subnet, I dont think per protocol, you may need to change the mode to active/active thou and you end up loosing some features. 

Mike.