Hi,
I can't access FWSM from VSS via session slot command:
VSS-Core#sh module switch 1
Switch Number: 1 Role: Virtual Switch Active
---------------------- -----------------------------
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
7 6 Firewall Module WS-SVC-FWM-1 SAD123602F3
Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
7 0022.55b3.941e to 0022.55b3.9425 4.3 7.2(1) 4.0(8) Ok
VSS-Core#sh module switch 2
Switch Number: 2 Role: Virtual Switch Standby
---------------------- -----------------------------
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
7 6 Firewall Module WS-SVC-FWM-1 SAD112105JN
8 8 Network Analysis Module WS-SVC-NAM-2-250S SAL1523FE13
Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
7 0013.80f7.d70c to 0013.80f7.d713 4.3 7.2(1) 4.0(8) Ok
8 f866.f2b2.2410 to f866.f2b2.2417 1.2 7.2(1) 5.1(1) Ok
transport telnet is enabled on VTY's
VSS-Core#session switch 1 slot 7 processor 1
The default escape character is Ctrl-^, then x.
You can also type 'exit' at the remote prompt to end the session
Trying 127.0.0.71 ...
% Connection timed out; remote host not responding
The same is for switch 2
Reloading VSS boxes didn't help. I can connect to admin context via SSH , but i want to have access via session command also.
Also i have NAM module in switch 2 , which is also inaccessable, hovewer at the same time i can access WISM blades via session command (probably becasue they use separate IP space from separate pool for service interface)
sh tcp brief didn't show any stale connections to 127.0.0.xx space
IOS - 122-33.SXJ5
Anyone met with this problem ?
