Change from Multi Context to a Single context - FPR-2120 ASA image

[ValterPN]

Hi all,

I need to change the firewall mode from multi context to a single context and I have only one context configured.

Checking the files in the SYS context I can see:

old_running.cfg   /   admin.cfg   /   mycontext.cfg

The actual context(mycontext) I have anyconnect vpn configured.

What's the best approach to do in this case?

                - Use backup and restore command in the sys context?

                Or

                - Copy running-config context and paste after mode is single?

I can´t lose my anyconnect configuration and my certificates.

I appreciate any help.

Regards,

Valter

[ValterPN]

Well guys...

I decide to go through  

SYS#  backup /noconfirm context blabla pass cisco location disk0:

and restore, but you need to no shut in the port-channels and config the vlan in the interfaces.
The certificates was transfered with success.
The only problem was in the anyconnect vpn (Webvpn) that is not authenticate users.....I'm searching a solution yet.

[Marvin Rhoads]

Is it only authentication that's failing?

Can you share the details of that problem?

[ValterPN]

Hi Guys, The Key was wrong. After put the correct one, all works fine.

Many thanks.