02-23-2005 10:21 PM - edited 02-20-2020 11:58 PM
Hi!
I would very much appreciate your help with how to connect and configure a Cisco 2600 Router and Cisco Pix 501 Firewall. I am pretty new to this an would like to know whether to connect the T1 to firewall and the firewall to the router or the other way round.
Your help and suggectons are greatly appreciated.
Thanks!
Youssef
02-24-2005 08:10 AM
The PIX does not support any other interfaces other than ethernet. So, if you need to terminate a T1 interface, you will need to terminate this on the 2600 and then connect the PIX in via ethernet. Presumably, your internal hosts would then be connected to the PIX. Something like this:
T1----2600----PIX----internal hosts
Does this make sense?
Scott
09-04-2010 11:51 AM
I have the following setup.
cisco 2600 Ethernet0/0 to ISP, Ethernet0/1 192.168.0.1 that goes to my Pix 501 Outside interface 192.168.0.2 and the inside interface is 192.168.1.1.
All my internal user are conected to a switch which is connected to the Pix 501 and they all have internet access; However when I try to connect from anywhere to my webserver on port 80 it won't let me.
On the router I have the following:
ip nat inside source static tcp 192.168.0.200 80 PUBLICIP 80 extendable
on The Pix I have the following:
access-list outside_access_in permit tcp any host 192.168.0.200 eq www
static (inside,outside) 192.168.0.200 192.168.1.200 netmask 255.255.255.255 0 0
I think my problem is on the router not sending the request to the firewall, but it's just driving me nuts.
Any input will be greatly appreciated.
09-04-2010 05:12 PM
Please perform "clear xlate" and "clear arp" on the PIX, and also make sure that on the router ARP for 192.168.0.200 points towards the PIX outside interface MAC address.
Hope that helps.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide