I need some help here...
I have setup my router with a loopback that's not routed and matched the loopback with the IPS ie
"interface IDS-Sensor2/0
ip unnumbered Loopback2
service-module fail-open
"
I can access the IPS using the "service-module IDS-Sensor2/0 session"
Now I have setup the management with a IP on my management network.
I can ping my Management gateway / DNS / and NTP servers.
However I can not connect to the IPS's web interface.
When I ran the setup I have activated the interface.
From the router I can see it's "suppose" to be up
<myrouter>#service-module IDS-Sensor2/0 status
Service Module is Cisco IDS-Sensor2/0
Service Module supports session via TTY line 131
Service Module is in Steady state
Service Module heartbeat-reset is enabled
Getting status from the Service Module, please wait..
Cisco Systems Intrusion Prevention System Network Module
Software version: 7.0(2)E4
Model: NME-IPS
Memory: 443504 KB
Mgmt IP addr: <Removed>
Mgmt web ports: 443
Mgmt TLS enabled: true
Does anyone have any idea's what I can look for? - Thanks