05-08-2019 11:39 AM
Hi,
I have setup a ASA 5506-X in my office like this (pls see the commands below). In Setup Wizard, I use Anywhere Connect VPN to connect to office from home. Connection status shows success and I got an IP with correct Default gateway: 192.168.1.1. However, I can't access Internet or ping any other computers in LAN network (at office). I can't even ping the gateway 192.168.1.1. Computers at office can access Internet normally.
Please show me where I make mistake.
Thank you!
!
interface BVI1
nameif inside
security-level 100
ip address 192.168.1.1 255.255.255.0
!
ip local pool Inside_network 192.168.1.151-192.168.1.200 mask 255.255.255.0
!
interface GigabitEthernet1/1
nameif outside
security-level 0
ip address <public IP> 255.255.255.240
!
interface GigabitEthernet1/2
bridge-group 1
nameif inside_1
security-level 100
!
interface GigabitEthernet1/3
bridge-group 1
nameif inside_2
security-level 100
!
same-security-traffic permit inter-interface
same-security-traffic permit intra-interface
!
object network obj_any1
subnet 0.0.0.0 0.0.0.0
!
object network obj_192.168.1.0
subnet 192.168.1.0 255.255.255.0
!
object network obj_any1
nat (inside_1,outside) dynamic interface dns
object network obj_192.168.1.0
nat (inside_2,outside) dynamic interface dns
route outside 0.0.0.0 0.0.0.0 <public IP>
!
dhcpd dns 8.8.8.8 4.2.2.2
dhcpd auto_config outside
!
dhcpd address 192.168.1.50-192.168.1.150 inside
dhcpd enable inside
!
Solved! Go to Solution.
05-09-2019 08:32 PM
05-09-2019 08:32 PM
05-09-2019 10:23 PM
05-10-2019 05:38 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide