Cisco ASA 5505 configuration help

[KatherineBoettcher87939]

The configuration for my device had to be reset. How do I get the old configuration so my printers and devices will work since it is off the old configuration IP addresses?

[Francesco Molino]

Hi
If you erased your config and you don't have any backup (not on asa disk or elsewhere), you can't go back to the old config and you'll need to rebuild it from scratch.

[KatherineBoettcher87939]

How do I rebuild from scratch?

[Francesco Molino]

If you have access to CLI, when you enter the command config factory-default and then reload save-config noconfirm, the ASA will be in a default state the way it was shipped.
If you don't have access to the CLI, you'll need to use the button on the back. Switch if off, then press and hold it for 10s while you powering it up.

[KatherineBoettcher87939]

What is CLI?

--
Katherine Boettcher

Practice Administrator

Chesapeake Ear, Nose, and Throat, LLC, A division of

www.baltimoreent.com [1]



Links:
------
[1] http://www.baltimoreent.com

[Francesco Molino]

CLI = Command Line.
Access it using a console cable connected to the console port on the back of the device.