cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
291
Views
0
Helpful
2
Replies

Cisco ASA 5510 DMZ No ping from host inside to gateway

AlessandroDP211
Level 1
Level 1

Hello everyone,

I can not connect to the internet or ping the gateway or the outside interface from my host in the inside network. 

These are my settings:

:
: Serial Number: xxx
: Hardware: ASA5510, 1024 MB RAM, CPU Pentium 4 Celeron 1599 MHz
:
ASA Version 9.1(7)32
!
hostname xxx
enable password xxx encrypted
xlate per-session deny tcp any4 any4
xlate per-session deny tcp any4 any6
xlate per-session deny tcp any6 any4
xlate per-session deny tcp any6 any6
xlate per-session deny udp any4 any4 eq domain
xlate per-session deny udp any4 any6 eq domain
xlate per-session deny udp any6 any4 eq domain
xlate per-session deny udp any6 any6 eq domain
passwd xxx encrypted
names
!
interface Ethernet0/0
nameif outside
security-level 0
ip address dhcp setroute
!
interface Ethernet0/1
nameif inside
security-level 100
ip address 192.168.97.1 255.255.255.0
!
interface Ethernet0/2
nameif dmz
security-level 50
ip address 192.168.98.1 255.255.255.0
!
interface Ethernet0/3
shutdown
no nameif
no security-level
no ip address
!
interface Management0/0
management-only
nameif MGT
security-level 100
ip address 192.168.99.6 255.255.255.0
!
boot system disk0:/asa917-32-k8.bin
ftp mode passive
same-security-traffic permit inter-interface
same-security-traffic permit intra-interface
pager lines 24
logging asdm informational
mtu MGT 1500
mtu inside 1500
mtu dmz 1500
mtu outside 1500
no failover
icmp unreachable rate-limit 1 burst-size 1
asdm image disk0:/asdm-762.bin
no asdm history enable
arp timeout 14400
no arp permit-nonconnected
route outside 192.168.97.0 255.255.255.0 192.168.8.1 1
timeout xlate 3:00:00
timeout pat-xlate 0:00:30
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00
timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00
timeout sip-provisional-media 0:02:00 uauth 0:05:00 absolute
timeout tcp-proxy-reassembly 0:01:00
timeout floating-conn 0:00:00
dynamic-access-policy-record DfltAccessPolicy
user-identity default-domain LOCAL
aaa authentication http console LOCAL
http server enable
http 192.168.1.0 255.255.255.0 MGT
http 192.168.99.0 255.255.255.0 MGT
no snmp-server location
no snmp-server contact
crypto ipsec security-association pmtu-aging infinite
crypto ca trustpool policy
telnet timeout 5
ssh stricthostkeycheck
ssh timeout 5
ssh key-exchange group dh-group1-sha1
console timeout 0
dhcp-client client-id interface outside
threat-detection basic-threat
threat-detection statistics access-list
no threat-detection statistics tcp-intercept
ssl encryption 3des-sha1 aes128-sha1
webvpn
anyconnect-essentials
cache
disable
username xxx password xxx encrypted privilege 15
username xxx password xxx encrypted
!
class-map inspection_default
match default-inspection-traffic
!
!
policy-map type inspect dns preset_dns_map
parameters
message-length maximum client auto
message-length maximum 512
policy-map global_policy
class inspection_default
inspect dns preset_dns_map
inspect ftp
inspect h323 h225
inspect h323 ras
inspect rsh
inspect rtsp
inspect esmtp
inspect sqlnet
inspect skinny
inspect sunrpc
inspect xdmcp
inspect sip
inspect netbios
inspect tftp
inspect ip-options
!
service-policy global_policy global
prompt hostname xxx
no call-home reporting anonymous

 

 

On my host I have the settings IP: 192.168.97.5 NM: 255.255.255.0 GW: 192.168.97.1

 

In packet tracer it shows me, that the implicit rule is dropping the package, I already tried to create a rule, which is letting all traffic through, but it still did not work.

I will be very thankful for everyone helping me.

2 Replies 2

@AlessandroDP211 you need to configure NAT, example:

object network INSIDE
subnet 192.168.97.0 255.255.255.0
nat (INSIDE,OUTSIDE) dynamic interface

To enable ping from the inside to the internet

fixup protocol icmp

 You cannot ping the IP address of the ASA's outside interface when connected to the inside interface, that's by design. You can only ping through the ASA to a device on the other side of the ASA.

only config

inspect icmp 

Review Cisco Networking for a $25 gift card