cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
680
Views
0
Helpful
1
Replies

Cisco ASA 5565

susinkumar
Level 1
Level 1

how to enable the telnet in ciscoASA 565 model firewall please suggest me anyone 

1 Reply 1

Marvin Rhoads
Hall of Fame
Hall of Fame

There is no such model as a 5565 or 565.

That aside, one enables telnet via the command:

     telnet <source address> <netmask> <source_interface>

...filling in your local information for each of the bracketed fields. For example:

     telnet 0.0.0.0 0.0.0.0 inside

...would allow telnet for any host via the inside interface.

Reference.

Note that it is recommended to NOT use telnet to access a firewall as you would be using an insecure access method to access a security appliance.

Review Cisco Networking for a $25 gift card