cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

414
Views
0
Helpful
3
Replies
Highlighted
Beginner

Cisco ASA - add route

Hi guys! I using GNS3 simulator with that kind of image of ASA.

I have two questions:

1) Why when I added static route it's does't show up in routing table?

2) Does it possible to configure with that image site-to-site ikev1/IPsec VPN for Lab's purposes?

Please take a look to screenshots

 

Screen Shot 2018-10-11 at 17.56.47.pngScreen Shot 2018-10-11 at 17.59.55.png

Also when I did remove "1 track 7" it started to ping

but I did't configure anything where were "track 7" used...

s.png

3 REPLIES 3
Highlighted
VIP Mentor

Do you have any IP sla configuration in your config? check or post full configuration.

 

Site to site vpn is possible, if it demo you have limited throughput available for test.

 

but for testing concept it is ok.

BB
*** Rate All Helpful Responses ***
Highlighted
Hall of Fame Guru

The interface must be up for a route to be installed in the routing table.

 

Also since you were tracking against a non-existent ip sla operation that would also prevent the route from being installed.

Highlighted

Ok! IP SLA not exist -it's explains! Thanks a lot!
Content for Community-Ad