You can't unfortunately specify just the firewall section for read/write access.
You can configure command authorization for specific command that you would like read/write access, however, in your case, the command would be access-list and access-list can belong to different section, ie: firewall, NAT, VPN, etc.
If you are interested, here is the document on command authorization for you reference:
Hi ,I would like to know IP and mac address filtering.i have the one webserver.So i would like to restriction to access to web server.I would like do the whitelist to access webserver. i would like to do both IP and MAC filtering to access server.for exam...
Over the past decade, Cisco has published a wealth of security and threat intelligence information for security professionals interested in the state of global cybersecurity. The Cybersecurity Report Series provides detailed accounts of threat landsc...
You will need to make sure that you have Orbital access before we begin. You need to be an AMP for endpoints Administrator, Advantage tier licensing or higher and you'll need at least one host with Orbital installed and connected to th...
When I log into SecureX, I'm given an option to Sign in with MIcrosoft. What information is shared from my profile with Cisco?
1. If you signed in with your work email, the information shared from your profile is controlled by your or...
Stealthwatch Enterprise can be leveraged to monitor vulnerable devices, and alert on potential exploitation by bad actors looking to exploit Ripple20 and other potential vulnerabilities.
Note that the concepts and procedures outlined here can be used for...