Cisco ASA FTD - QoS through FDM

[pgiouvanellis]

Hello everyone ,

We have an installation on a Cisco ASA FTD Image which we managed through FDM and not FMC .

Is there any way to perform QoS , we basically need to give priority to a specific network flow ? 

Is there any way to implement this to ASA through FDM or FlexConfig ?

Also I would like to ask if anyone know if the FTD do packet-capture caused on intrusion policy by its own and if yes how we can change this .

I am asking this cause we had a problem with the disk of the ASA and we found that there was some .pcap files 

that causes the problem and make the disk to be fulled.

Thank You,

Palaiologos

[Sheraz.Salim]

check this document.

https://www.cisco.com/c/en/us/td/docs/security/firepower/610/configuration/guide/fpmc-config-guide-v61/quality_of_service_qos_for_firepower_threat_defense.pdf

[pgiouvanellis]

There is no such a choice on FDM interface .

I beleive this guide is for FMC  not for ASA managed through FDM .

Thank you

[Leon1]

Have you ever resolved this? I need to configure QoS on the FDM also, but I cannot find any information about to get this done. Maybe it could be done through FlexConfig?!

[bcoverstone]

I need to configure QoS as well. I can't believe FDM cannot handle this!!

[Ilkin]

As of now, QoS is not supported on FDM.

[bcoverstone]

The problem here is the Firepower 1010 series for small business costs less than purchasing FMC.

But a lot of small businesses have ASA's that have some form of QoS at some point set up, and it needs to come over or most of these customers will not purchase FTD's.

What about Flex Config?