Cisco ASA

[philbert_manalo]

hi Cisco,

i am configuring Cisco ASA 5508-x on our network, on the interface Gig 1/2 "inside" i am using the gateway 192.168.1.1 and it works well, i can still open the ASDM launcher, but  it fails when i am trying to use 192.168.0.1 on the same interface? thank you!

Regards,

Philbert

[Marvin Rhoads · Accepted solution]

Do you mean you are trying to change the interface address to 192.168.0.1? Is your client that's running ASDM on that same subnet?

If not, does the ASA have a route to the subnet where the client is located? If so, have you allowed http(s) (used by ASDM) from the client subnet?

[philbert_manalo]

hi Marvin,

 thanks for the help! i can now use it by allowing the 192.168.0.0 range to access http.

thank you!

Philbert