CISCO FIREWALL 3105

[Tech12]

Hello 

We just got a cisco FIREWALL FPR3105-NGFW-K9 and very exited but we have failed to get the an ip address through DHCP even after connection to he INSIDE PORT. As a mater of fact the port is not lighting at all but the out side port is lighting any suggestions on how to go about this. we tried using the console and also ran the command "connect ftd" the show ip and there was 192.168.95.1 on the inside interface but still the interface was kind of inactive.

how do i get to the 192.168.95.1 from the browser 

[MHM Cisco World · Accepted solution]

Use mgmt port to connect your PC and start FDM 

MHM

[Tech12]

should i asign my self an ip?

[MHM Cisco World · Accepted solution]

The mgmt use 192.168.95.1 

You need to assign Ip to your PC with any IP in that subnet 

Abd use 192.168.95.1 in browser 

MHM

[wajidhassan · Accepted solution]

To access 192.168.95.1 via browser:

1. Connect your PC directly to the Management 1/1 port.

2. Manually set your PC’s IP to:

   • IP Address: 192.168.95.2

   • Subnet Mask: 255.255.255.0

   • Gateway: leave blank (optional)