cisco ime using local proxy server
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-04-2013 02:35 PM - edited 03-10-2019 05:56 AM
folks
i've a strange process going on
ime can't connect to any of my sensors and when i run a packet capture it looks like its using an old proxy server i had configured some time ago
i've checked that IE isn't configured for a proxy but can't find where ime is picking it up from
anyone any ideas?
thanks
- Labels:
-
IPS and IDS
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-04-2013 10:07 PM
Hello Sr,
I can ensure you that there is one proxy between the IME workstation and the IPS sensors, it might be taking it from the Java setup.
This of course might cause you problems while attempting to connect to the sensors,
What are the work-arounds/solutions for this:
1)Create an exception rule on the Proxy server
2) Remove the Proxy server
3) Try to connect from a workstation that does not go through that Proxy-server
4) Go to Control Panel > Java > General > Network Settings - Select direct connectio
Remember to rate all of the helpful posts, that is as important as a thanks
Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC
